MC2 Audio E100 Instructions d'exploitation télécharger pdf (Page 13)

E Series – E100 Operating Instructions

Page 13

Connecting To Your Amplifier: Bridged (Mono) Operation

Pairs of channels may be independently bridged — channel pair A&B, and/or channel pair

C&D.

The method is the same for both channel pairs:

Supply signal to Channel A or C input only and push in the appropriate rear panel switch

marked “BRG A&B” or “BRG C&D”.

Use Channel A or C’s Output Speakon connector and connect as follows:

Pin 2+: Hot

Pin 1-: Cold

When operating in bridged mode, the minimum impedances are doubled.

The minimum load in bridged mode is 4 ohms.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

MC2 Audio E100 Instructions d'exploitation Page 13